Our Products

Our Products

U-Stripe It & Design ToolU-Stripe It & Design Tool

Striping a Room in Just 3 Easy Steps

STEP ONE:

Determine the desired width of the stripes you want to create, and then lock the tool in place. (When locking the tool, place it on a hard surface then fasten tightly the wing nuts.)


STEP TWO:

Place the tool in the top corner of the wall; be sure to check the level to assure accuracy. Using 1” 3m Scotch Blue Delicate Painters Tape, place the tape on the outside of the tool, extending it from top to bottom, creating you first stripe to be painted.


STEP THREE:

Position the tool over the tape, which was just placed on the wall during step two, using the inside of the tool as your guide; place the next strip of tape on the outside of the tool extending it from top to bottom. Remember this is you non-painted stripe, it will appear smaller.

After Step Three, place the tool on the outside of the tape, which was just placed on the wall during Step Three, using the full width of the tool repeat Step Two, then repeat Step Three, until the room is completed. Again Step Three is the Non-Paint Stripe and is going to appear to be smaller.

In just 3 steps and 1 gallon of paint – you can have the room you’ve always dreamed of!

Leave a Comment:

U-Stripe It & Design Tool-Review and Giveaway

After buying a very run-down hundred-year-old house, my husband and I are quickly learning that our plans for the future aren’t about what to renovate, but are about what to renovate first. Half of the house is an unfinished addition and the other half was last updated in the late seventies, so there are very few areas that don’t need to go through major changes to turn our house into the palace that we dream of.  To read more go to:

http://www.mommykatandkids.com/2011/02/u-stripe-it-painting-and-design-tool-review-and-giveaway.html
Bookmark and Share
·  Store  ·  Instructions  ·  FAQ   ·  Events  ·  Blog  ·  Contact Us  ·  Links  ·  Shipping  ·  Terms and Conditions  · 
Copyright © JTEKE, LLC
Manufacturer of the U-Stripe It & Design Tool
All Rights Reserved

phillipmenendez@ustripeit.com